MuuMuu101's 68 Dart, A Learning Process...

Went to the pick-a-part today and pulled out the brake pedal assembly out of the 75 Valiant so I don't have to reweld, measure, and drill holes into the one I had. I tried getting the spindles out of the Cordoba but I was getting tired (went after work) and I didn't have the right hammer to get the studs on the UCA off the spindles. O well, it's not a necessity. I have pictures but it's taking forever to email them to myself.

Plan on getting back on the Dart in a week. I have finals this week. Hopefully I pass my classes with all the school I missed from baja.

I also just realized that my previous post was awfully wacky as I copied and pasted it off of moparts. Basically this is what needs to get done:

1) Press wheel studs in rotors/hubs (FABO member offered to help me with that)
2) Replace/rebuild calipers
3) Clean welds on firewall from replacement panel
4) Weld new "ears" (for MC mounting location) for brake pedal mount
5) Drill holes in firewall and brake pedal mount to mount MC
6) Install and bench bleed MC
7) Bend and install new brake lines from Distribution Block to MC
8 ) Bleed entire system
9) Install Steering Column (ready to go)

Number 4 is done since I bought a new pedal assembly... :D

Hope to get back on the Dart in a week or so. Kinda anxious as I'd just like to drive the freakin car...