Curleysparts

Just for the record, as I happened to stumble upon this thread...I have been in contact with this customer, and asked him to send me the control arms back. I told him I could not do anything without seeing them in person. This would be the standard response for any aftermarket component company.
The customer himmed and hawed about doing so, and has since stopped communicating. As of now, I consider the issue resolved, and will not wait around and play games to remedy any problems. I cannot see from the pictures, but they CAN be installed on the wrong side of the car....

The fixture these are built from was checked with 3 sets of factory control arms, and then had an additional 3* of castor added to the fixture. During the fabrication process, I believe there were 3-5 threads showing on the heims(cant remember exactly). Even so, the customer admitted he threaded the heim joints out so far, that they ended up pulling the threads out of the control arms(which he admitted was probably his mistake). He said this was necessary in order to get proper geometry. This, I cannot figure out...

So all in all, flame on. I was NOT avoiding this thread...I just got a sour taste in my mouth about the Mopar community as a whole and stopped coming around. Thank you to everyone who has purchased products from me in the past and who has given me good feedback. It is much appreciated.