HELP!!! Hughes Retro Fit Roller Lifters Problems

I was finally able to here your video!!!!!!

pull them valve cover off, get a adj push rod, and find out how deep them lifter need to be preloaded and set it. send that push rod out and have 16 new ones build.

I Hyd lifter will not pump up if it has too much or not enough preload in the lifter.

When the pushrods set the proper preload of the lifter and it still is noise, THEN you will need to replace them as well.

LIFTER PRE LOAD IS YOUR ISSUE.

You need to make sure you have enough valve to guide/spring for the lift that you have. this is vary important!!

You just might find bent push rods when you get into it.

Get the valve cover off and see what you see