Breathing new life into the 318 in the Scamp!
Got the heads pulled. I still don't know what's up with them, until I check them. I'll likely have them milled, which is going in the tighter direction. It's already at 9.75:1 static. I may ditch the .028's and go with something bigger, depending on how much needs trimmed.
I guess I'll be waiting until I get them back, check CC again and buy gaskets after I know my numbers. Don charges $60 for milling on both heads. Not too bad, if that's the route I go. I have no idea on gaskets just yet. 3rd time's a charm on those.
4:30pm -
6pm -
Frowny face.
Got the heads pulled. I still don't know what's up with them, until I check them. I'll likely have them milled, which is going in the tighter direction. It's already at 9.75:1 static. I may ditch the .028's and go with something bigger, depending on how much needs trimmed.
I guess I'll be waiting until I get them back, check CC again and buy gaskets after I know my numbers. Don charges $60 for milling on both heads. Not too bad, if that's the route I go. I have no idea on gaskets just yet. 3rd time's a charm on those.
4:30pm -
6pm -
Frowny face.