'68 Barracuda Notch
I've done a little work on the floor. I found someone with a floor section that is going to help me out, but it will probably be a couple weeks until I can get it.
I filled in the two slots near the gas pedal. There was a pretty big gap in some spots and it took a while to get it filled. The metal was a little thinner than I thought and my Harbor Freight welder doesn't adjust down very far on gas. Its pretty solid now though. Admittedly there are a couple tiny pin holes that some seam sealer will take care off. I also patched the torsion bar cross member too.
Both are a little rough, but this is my first welding project, so I'm happy.
I've done a little work on the floor. I found someone with a floor section that is going to help me out, but it will probably be a couple weeks until I can get it.
I filled in the two slots near the gas pedal. There was a pretty big gap in some spots and it took a while to get it filled. The metal was a little thinner than I thought and my Harbor Freight welder doesn't adjust down very far on gas. Its pretty solid now though. Admittedly there are a couple tiny pin holes that some seam sealer will take care off. I also patched the torsion bar cross member too.
Both are a little rough, but this is my first welding project, so I'm happy.
