Rear crossover pipe????

There was a system that did just that, became part of Accel? I believe, was orginally Roto-Master "All the junk" that the carb sets on you would not have to use. This was supposed to act like a low RPM bypass deal so that the carb fed the engine "straight through" at no boost


http://www.forabodiesonly.com/mopar/showthread.php?t=222990

From this thread:

http://www.forabodiesonly.com/mopar/showthread.php?t=187891

is this photo of the special passenger side manifold they used



From this thread is the "Chivvy" version:

http://www.theturboforums.com/threads/352986-can-i-run-my-turbo-drain-in-to-my-valve-cover

In the photo below, the crossover comes off the flange pointing to the rear inline with the manifold right below the turbo, goes down and around, and up to the other manifold, almost like a factory Y pipe




Another:

This manifold goes on the pass. side, the downpipe is the crossover, and the main exhaust comes off the turbo at upper left.

http://www.forabodiesonly.com/mopar/showthread.php?p=1969435176