Supposedly overcammed works out.....

Abodybomber said
This thread is about big cam grinds,that shouldn't work,but do.All the cam tech guys say " too big!",but you did it anyway.(lol). Mine,mild 408,9.7 real world compression.Mildly worked Eddys,air gap manifold.Chose a old Comp 312h-06.Hyd flat tappet,[email protected],106 I/c installed at 104 per cam card. Was mildly surprised,at the responsiveness of ole biggie.Idled about 1100 in drive,with a wicked chop.Mid range torque ,off the hook. For reference,this cam 2 sizes bigger than the Comp 305 Magnum.What's your story?

I guess the question is kinda vague to me. I only concern myself with ET slips. Idle etc ar not at the top of my list of what means a cam works. Yes, I've run the large Comp [email protected] hyd cam in a 360 20 years ago. It ran well with 4.56 gears and loose converter,but I've built lot's of combos that were better with other grinds. I've been over and undercammed on many visits to the track.LOL