I would like to go roller, but with my current situation funds will not allow it which was why I was going back to a hyd flat tappet setup. I can always upgrade to a roller later on down the line.
If you're already buying pushrods, the hydraulic roller cam setup is about $715. Most flat cams are $170ish. So, yes, its $545 more, but seriously, it works awesome...my cam in my 340, mentioned above that made 470hp is only 227/231 with .530" lift. Save for a little longer and get it.
My engine also has the Crane Golds as well...look like a nice piece since they were used when I bought them and other than a couple that had some pitting from sitting around and were replaced, they looked fantastic.
