Difference in Victor and Super Victor Intake

rumblefish360 said

I figured the SV was for best use under a serious stroker. Just where this takes place over a regular Victor is a good question.
Now the SV is a standard bolt hole intake? Not a W series spacing right....
What heads are out there capable of making excellent use of this? The Indy head? Not Indy/Brock head.

Tony, what head are you making use of with the SV?
Skrews, what are your Indybrocks flowing?

Click to expand...

My IndyBrocks were CNC ported by Indy. Flowed 288 peak OOTB with poor mid lift numbers. I redid the valve job and replaced the valves. These mods picked up the mid lift numbers as much as 30 or so cfm, and peaked at 292. The bench used is a little stingy though.
IMO the only heads that will truly utilize the potential of the Super Vic are IndyBrocks or the 220 AirWolf heads. These have the kind of cross section to match well with this intake. I'm planning on building a 14:1 compression 4" stroke 4.08" bore 418 cube stroker motor with my IndyBrocks and my Super Vic. Planning on a 4/7 swap cam in the .700 lift range with around 270* duration @.050. Should make 650+HP.