318 no start after sitting

Like I said I have all the data sheets and have been looking at them.
This is it
http://www.msdperformance.com/Produ...sler,_318,_340,_360,_E-Curve_Distributor.aspx

I'm just a little baffled on why there wouldn't be any voltage to it on the run setting.

I took the connector for the distributor, hooked up my voltage meter to the 12v+ pin and took the other lead to a ground on the frame, read 12v+. Did the same thing for the ground or negative pin on the connector, got 12v+ to the battery+. SO there's no loose connection in the wiring there so there should be 12v+ between the two pins going into the distributor
BUT if you check both the pins there's no voltage, wtf there's no switch and there should be.

I've got through the 6A tips and it's all checked out so far