flowed my magnum heads for my 360 build.

Hey all! finally finished up my magnum heads. Stock castings, ebay stainless valves, stock valve size. Good 3 angle valve job on the intake, only 2 angle on exhaust. Anyways did some cleanup on the pockets, a little on the pushrod pinch, and guide boss. opened up the small exhaust port a little, had a tough time with the short turn on the exhaust, didn't respond well. Did some minor de-shrouding in the chamber didn't want to drop the cr. I think they respond very well with the work done.
These are my #s at 28" cfm rounded to nearest #.



lift Int ext
.100 69 60
.200 138 118
.300 199 155
.400 222 170
.450 239 181
.500 248 183
.550 252 183


These heads are going on my .030 360, compression will be 9 to 1
cam is xe262, will be using 1.6 ratio rockers so lift will be lift will be .493
.501. air-gap intake, the heads above, 650 holley, long tube 1 5/8 headers.
I think it will make close to 350 hp 400 ftlb, what do you guys think?