360 46RE driveline swap, wont shift

The Vehicle Speed Sensor (VSS) is no longer used for any Dodge Truck.

Vehicle speed and distance covered are measured by the Rear Wheel Speed Sensor. The sensor is mounted to the rear axle. A signal is sent from this sensor to the Controller Antilock Brake (CAB) computer. A signal is then sent from the CAB to the Powertrain Control Module (PCM) to determine vehicle speed and distance covered. The PCM will then determine strategies for speed control system operation.

I would bet if you could read codes you would have P0500 set
SYMPTOM
P-0500 NO VEHICLE SPEED SENSOR SIGNAL

TEST NOTE
All symptoms listed above are diagnosed using the same tests. The title for the tests will be P-0500 NO VEHICLE SPEED SENSOR SIGNAL.

SET CONDITION 1
The code is set if no Vehicle speed is received from the CAB Module for more than 15 seconds for 2 consecutive trips.

WHEN MONITORED 1
With the Engine running, Automatic Transmission in drive, and Output shaft speed greater than 64 rpm , ECT above 104°F , MAP vacuum 15 to 16" and Engine rpm greater than 1500 .

SET CONDITION 2
This code will set if no Vehicle Speed Signal is received from the CAB (Controller Antilock Brakes) Module for more than 15 seconds for 2 consecutive trips.

POSSIBLE CAUSES
Cab module diagnostic trouble codes
Vehicle speed signal circuit open
Vehicle speed signal circuit shorted to voltage
Controller antilock brakes defective
PCM defective (no vehicle speed sensor signal)
Vehicle speed sensor wiring harness observable defect
Vehicle speed signal circuit short to ground

The only version that will work that i know of is a 46rh with out the pcm controll of the shifting.