Brazilian Dodge Dart 76 (similar to 69 usa)

Hi,
1st. remove damper pulley screw washer. Put this big screw again in the same place.
2nd. install the drilled plate as show in pictures. I installed the side screws first. After that, I installed the center screw. I used a nut to hold it in place.
3rd. The main idea is, when you tighten this center screw, it will push the original pulley middle screw. As consequence, pulley will come out the engine.
You can also tight both side screws alternately (as I did).

Later I post the tool I made to install bushings. It is easy to reproduce. Basically it is a small piece of tube and a long screw (and some washers)