Is there a true plug-n-play setup for a 5.7 with FI yet?

We need to figure out the knock sensor thing.

I have the knock board in my megasquirt wired and ready, but I haven't connected it. Hemi sensors are NOT tuned to the correct knock frequency. We'll have to set that within the megasquirt tuning software.

Notes from discussing with Matt @ DIY auto tune:
-make sure you're actually getting feedback, otherwise you're on the wrong frequency
-try the fundamental frequency first, then the 2nd if you need to (can be calculated based on cylinder bore)
-'correct' way to 'set' it would be to record and play back through a spectrum analyzer
-they use headphones for tuning at their shop (not knock sensors)

I also spoke with someone associated with Mopar who said this:
There are 2 frequencies for the 5.7 and 6.4 Knock Sensors(part# 05033316aa). 1 is 5.9kHZ and the other is 13.72kHz.

I need to wire mine up and see what happens.

Map - you going to do it? I don't want to figure this out on my own!