SB Oil Galley Plug Depth?

Okay found this: [ame]http://www.jegs.com/InstallationInstructions/300/312/312-P5249261AB.pdf[/ame]

Apparently there's a step that it's supposed to come to a stop on....I think I drilled this passage all the way to 1/2" doing the oil mods....I think, lol, Now I have to check again. lol


[FONT=Arial Narrow,Arial Narrow][FONT=Arial Narrow,Arial Narrow]Be sure to check that the small cup plug has been installed in the oil passage between the #5 mains bearing cap and the main oil galley. If this plug is omitted in error, the engine will have very low oil pressure and the oil will not pass through the oil filter. This plug is installed before the #5 main cap is installed, and must be pressed all the way down onto a step in this oil passage. Use a flashlight and confirm that the oil will travel up from the oil pump and out the side of the block into the filter. From there the oil will pass through the filter and back into the block up into the main oil galley. Any time a block has been hot tanked or stress relieved, this plug must be replaced. For more information on this plug see the oiling section in the Mopar Performance book on [FONT=Arial Narrow,Arial Narrow][FONT=Arial Narrow,Arial Narrow]Small Block "A" Engines [/FONT][/FONT](P4876826)


[/FONT][/FONT]