Cinnamon 75 Duster \
I got the vinyl on. Went pretty well for another first time job. it does have a few marks where the hardest creases were. I think from rubbing them out I roughed up the surface slightly. Will try to get it as clean as possible and get some kind of sealer on those spots. I did get 70 plus day and a good bit of direct sun so the metal was nice and toasty before I started. The gutters would have been a lot easier if it had been 10-15 degrees warmer.
I put the front glass in since I this pic, but still have leaks on bottom. Initially just laid butyl caulk rope in the flange before I set the gasket in. Thought it was pressed in good, but somehow water is getting through. It is getting by the metal, glass is not leaking. I tried forcing windowweld sealant down by the gasket today with caulk gun and It is better, but I think I need to get more under where the clips are, If I cant get it sealed soon, I will pull it and that lower part of the seal will be floating in goo before it goes back together...
I got the vinyl on. Went pretty well for another first time job. it does have a few marks where the hardest creases were. I think from rubbing them out I roughed up the surface slightly. Will try to get it as clean as possible and get some kind of sealer on those spots. I did get 70 plus day and a good bit of direct sun so the metal was nice and toasty before I started. The gutters would have been a lot easier if it had been 10-15 degrees warmer.
I put the front glass in since I this pic, but still have leaks on bottom. Initially just laid butyl caulk rope in the flange before I set the gasket in. Thought it was pressed in good, but somehow water is getting through. It is getting by the metal, glass is not leaking. I tried forcing windowweld sealant down by the gasket today with caulk gun and It is better, but I think I need to get more under where the clips are, If I cant get it sealed soon, I will pull it and that lower part of the seal will be floating in goo before it goes back together...