Will GM 200r4 work with factory floor shift location?

Thought I'd give everyone an idea of what I'm shooting for when it comes to setting up a 700R4 or 200R4 TV cable. TCI and others sell an adapter bracket for Holley and Edelbrock carbs to get the correct distance from the center of the carb shaft to the TV cable pivot point. I have a set of digital calipers so it's very easy for me to drill a hole in the exact location on the carb lever. But you also have to make sure you get the full angle of movement as required by the diagram. Either way if you get the TV cable attached to the carb lever in the correct location you won't have any problems. I believe the Holley I have has a Chevy lever on it but I can't check it until tomorrow. If it have a Chevy lever then the hole should already be there. The Mopar accelerator attach point isn't as critical but it's still important to get it right so get full throttle when you floor the gas pedal. See Pics.


It's still colder than H3LL outside!!!
treblig