Anyone using the MRL solid roller lifters?

A body said
My LA roller lifters are wrapped up and in a box "because" the W8 heads I'm running require an offset lifter, so in my case.."no", the lifter wouldn't work in a 48* R3 block. Brian did have the lifters built by his specs. Ours pushrod oiled as we ran the Erson rockers on our W5's.

Yes I called Brian today. I too am in the process of an R3, W8 or W9 Headed build. I did find an article online that talked about the offset lifters. However Brian was talking about different oiling coming off the lifters to feed the pushrods. I am learning as I go like usual.

http://www.moparmusclemagazine.com/techarticles/engine/mopp_0310_340_engine_600_hp/viewall.html

It's All in the Angle
Chrysler developed the R3 block because, traditionally, their blocks have 59-degree lifter angles, making it difficult for a high-rpm valvetrain to survive. The R3 block has the lifters at a 48-degree angle, giving a better pushrod angle. To begin with, our block (PN P4876672AB) was completely blueprinted. JMS drilled the oil galleys in the lifter holes because there were none there. Chrysler sells a jig to properly handle this task, but we're not sure why they don't drill them at the factory.
JMS also drilled oil drain holes at the top of the engine block, in the valley area, because without them, the oil would have to travel over a 1/2-inch-tall wall to reach the existing holes before it could drain back to the oil pan. This could effectively leave a quart of oil suspended up there at all times.
Because Chrysler moved the intake ports on the W-9 head to get the pushrod alignment straight, offset lifters needed to be used. JMS used a combination of centered, left, and right offset lifters. Neither Chrysler nor Comp Cams could clearly state what lifters were needed for this combination, but when it did come time for lifters, Comp was the only company that had offset lifters in a Mopar diameter. Each lifter had to be checked individually for geometry to see what offset was needed. Once the correct lifter offset was established, Comp Cams had to figure out what tie-bars were needed to connect the lifters. "Chrysler didn't know what lifters to use," said Mike. "They were on the phone with us asking what we came up with. That is why this motor is so cool. It's so new that even Chrysler is interested in what it took to put it together." The combination of lifters consisted of eight Comp Cams centered lifters (892C-1), four of the left offset lifters (892L-1), and four of the right offset lifters (892R-1). Eight Comp Cams link bars (CC814) hold the lifters together.

Read more: http://www.moparmusclemagazine.com/..._340_engine_600_hp/viewall.html#ixzz2n0oGeXfF