71 Duster 360 (new project)

Well..was trying to get alternator installed...and get the pullies lined up...after a couple of minutes of being puzzled...I realized I did not have Eddy heads...so I dont have that inch of aluminum overlapping the block and not letting the square back alternator fit...I just used the stock bushing...and bingo...the **** fit..

got trans cooler in...aluminum radiator bolted down...lower hose on ...then I can not find upper hose...after looking around where all the parts where went i torn the old engine out...nothing...So I sit down...and looking up...where all the intakes manifolds are sitting on a shelf...I see a hose still connected to the Air Gap intake....getting old sucks...

So waiting on headers...then connect shifting linkage...and put starter on....need to pull intermediate shaft out..and spin oil pump as this engine has not run in a good 2 years...and get shafts and stands bolted down...adjust valves in the old MP 590 cam......pour some corn syrup in the tank....and fire...