Does this look correct

Update:

I did a few tests and am still not getting a firm pedal.

Here are the tests and results:

With the master cylinder bolted to the car I plugged both front and rear ports with the plugs that came with the master = Nice firm Pedal = Master is good.

Left the rear pluged (Front brakes) and the front plumbed (rear brakes) and I got a better pedal.

Plugged the front (Rear brakes) and the rear plumbed (Front brakes) and I got the about the same result as above.

But with both lines plumbed, the pedal is spongy and has a lot of travel. I'm not sure what else to do.

I bench bled the master, and gravity bled the brakes for 1 1/2 hours. (Yes I did not let the master go dry.) It only emptied about half.

I am seriously at my wits end with these brakes. :banghead: I don't know what else to do.

Any ideas???