SRT8CUDA Build

Went through a lot of gnashing of teeth etc to get this bellhousing aligned OK. I first started to get the bore aligned, but then saw a post that you should get the face alignnment in spec first. To get the face parallel with the engine, I had to shim the top of the bellhousing out 0.015" at the top 2 bolts (used 0.005" shims on the next 2 lower bolts and no shims on the bottom 2 bolts. Final was 0.003" TIR (Specs are 0.006" TIR)
Then fought for a long time with 0.014" offset dowels to get the bore alignment done. Final was 0.002" TIR. (Specs are 0.008" TIR)
FINALLY finished this afternoon.
Did a trial fit of the tranny (no clutch) and it slipped right into the pilot bearing with no binding.
Now I can get the clutch installed and get the tranny bolted on and get this Hemi in the car!!