Cannot align A833 into bell housing!!!!

You don't have the pilot bearing in any of the pictures. I believe you are calling the throw out bearing the pilot bearing. The throw out bearing is the large bearing attached to the clutch fork. The pilot bushing is pressed into the back of the crankshaft. The "dummy shaft" is actually an alignment shaft the same size and spline count as the transmission input shaft.

The proper installation method for the clutch is like this. Assuming your pilot bushing is good, or has been replaced, position the pressure plate on the flywheel and start a bolt towards the top. Just a few threads. Pull the pressure plate away from the flywheel on the bottom and slide the clutch disk in. Take the alignment shaft and insert it through the throw out bearing and into the clutch disc and then into the pilot bushing, making sure that it inserts all the way in as far as it can go. Then start the remaining pressure plate bolts and torque them to spec and in the correct order. A simple star pattern works fine.

It sounds like you have not used the alignment tool, or did not get it fully installed and the clutch disc is not lined up. If you follow the above procedure, it will be fine.