SRT8CUDA Build

Finally got the exhaust system aligned like I wanted it. Needed lots of cutting and some bending to get it to fit. After:
- cutting 4" off the tailpipes, the tips fit OK
-cutting 1.5" off the H pipe crossover, the exhaust pipes fit together
-cutting 4" off the H pipe ends, so the mufflers would fit
-slotting the tailpipe hanger to raise the tailpipe
-bending the H pipe upwards (it was hanging too low at the rear) to allow the mufflers to fit and finally
-heating and bending the passenger side tailpipe hanger bracket (it was welded on crooked)
Other than that- it fit fine!!!
:banghead: