I can get good numbers having Modern Muscle cnc them. I will have half what a set of Thiteks cost when done. I can build more mounts in a solid setup later on once engine is back out. I have a good stock crank but figure if I have to buy rods and new pistons anyway might as well get a crank. I have some Manley 4.065x4.05 pistons already. Block is machined and ready just need to finish mocking everything up with car before I pull it back out and build it. Plan on wiring efi and everything else as well as finish engine compartment before engine is done so when it goes back together it will be to run and be done for a while.