360

Since I don't know how my scanner works, I took some pictures of some good information out of an old edition of "How to rebuild your small block Mopar" book. They took the information and ID section out of the latest editions. I also took close up views of the top and bottom of each section as I don't know it you will be able to read the picture of the whole page when posted. You can also right click on the pictures and save them to a folder in your hard drive, then right click on them in the folder and open them up in Paint and zoom in on the info. Excuse the oil stains, this book has seen alot of use:

Here's how to decode the VIN number for the vehicle in the driver's side of the dashboard:

Here's a picture of the whole page with the flash on:

View attachment VIN ID A01 B2.jpg

Here's a picture of the whole page with the flash off:

View attachment VIN ID A03 B2.jpg

Here's a close up view of the top portion:

View attachment VIN ID top B.jpg

Here's a close up view of the bottom portion:

View attachment VIN ID bottom B.jpg

Here's a view of the page that tells you how to decode the engine factory information stamped in the front of the block just under the head (shown in my previous post):

View attachment Engine ID A01 B2.jpg

Here's a close up view of the top portion:

View attachment Engine ID top B.jpg

Here's a close up view of the bottom portion:

View attachment Engine ID bottom B.jpg

Now you can get all giddy again and go check out what you have and figure it all out!!! Have fun!