Mopar head question-Thanks

A body said

"If your fabrication skills are not above average...."

I'd be the poster child for that comment! Still scratching my head on the motor plate deal. You don't just grab a catalog and order up a plate for an 9.2 deck R3 running a weber belt drive. I'm also fortunate to be 50 miles from a great header builder which is going to run about $1400.

Click to expand...

That really isn't bad. The un welded kit from Stahl was 500.00 , the flanges were 80.00 and the coating was 200.00 and a nice knife in trade for mine.
But given the hours I have in them ( over 40 I'd say ), that is not bad at all.
But it does require a lot of head scratching unless you have done it before.
Part of the charm is the unique aspect of the build.
I know I will be the only kid on the block with one for sure. :glasses8: