SRT8CUDA Build

Got the driveshaft from Action Machine installed, but it was about 1/4" too long and compressed the dust seal on the end of the tranny.
I measured the end play and have 9/16", instead of the usual 3/4" to 1". I have enough end play so I don't bottom out when driving, but I'll have to cut some off the end of the dust seal so it doesn't rub on the yoke.
Todd at Action Machine offered to take the shaft back and shorten it, but that is a major hassle to get it back and forth across the border.

The 3" shaft has Spicer 1350 U joints and yoke.