71 Duster 360 (new project)

LOL

anyway...got valve springs swapped out on eddy heads...new seals...set spring height at 1.80 as per springs..140 lbs at seat...

fel pro 1008 head gaskets showed up this afternoon...got heads bolted on...put lifters in bores...pushrods...put 1.6 crane rockers on....adjusted valves..

got Eddy Victor intake off shelf...washed the dust off it...sit it on engine...****...I can slide that intake all over the place...never knew it had been milled....pulled old mopar M1 that I had used on Demon last year...got old gaskets off..cleaned up it....fits perfect on heads...

took some pictures...but my laptop is not see my flash card....so will post later...

tomorrow i need to get transbrake old of other 904...then install in this 904...using TA 4400 series converter...same as in my Demon.....get motor and trans bolted together...and maybe take shot at putting in the Fuster...