Rapom's Rocket - just another Duster build thread

This pic shows the 2" (between arrows) I was talking about. I doesn't have to be exact but I wouldn't stray too far away from that distance. Normally it will fall in the center of the square that is formed by the 4 spot welds that join the clutch pedal to the linkage arm.

I rummaged through my nut and bolt box and found a full length threaded bolt and a couple of long nuts that I tacked together to make a bushing. Along with the heim bearing and a couple of washers this makes up the stand off. I did recess the hole with a small hole saw because the bushing wouldn't sit flush on the pedal which cocked the whole thing off alignment. Thought it was quicker than trying to cut the bushing on the correct angle. Easy peasy.

I left the linkage/return spring bracket attached so I have the Z bar set up available just in case this idea doesn't pan out. If the hyd does work I'll cut it off the pedal at a later date.