A833 Installation Opinion

Hello A-Body Folks.

I am about to install my 4spd finally (thanks forabodiesonly and brewer's). My question is; What is the best way to install this beastly, cast iron, nuclear war survivable bad boy?

I can't get it into position from under the car without a course of steroids and some more time at the gym, though I can borrow a transmission jack to see if that helps. I'm limited to pump jack heights where I'm working on the car, so keep that in mind. :)

Have folks bolted it all together and tried installing it through the engine bay? I've measured and it looks like it'll fit, though it'll be tight.

I could experiment, but I bet there is a few of you that "know" the only way this goes together.

Thanks.

--Neil