Fender emblem holes

This is what I did when I found the 360 call outs for my dart. My front fenders didn't have any holes and I could find out if they were drilled from the factory or not. I bought the 360 call outs that had the pins for said holes. I carefully used a bench grinder to grind the pins down then bought some 2 sided tape,( 3 M), cut pieces that were the same length as the callouts and then used a sharp razor blade to trim around the call out. Cleaned the area on the fender with a little rubbing alcohol, measured and placed on the car, still there. If you go this route do a little grinding at a time as to not heat up the callouts. I was able to take measurements off another car, with the owners permission of course, good luck. :supz: