First time rebuild problems-trouble upshifting

Got it fixed. Pulled the pan again to swap valve bodies and found a piece of a sealing ring lying in the bottom of the pan, and I immediately knew where it came from...

When I intially assembled the unit, I had a lot of trouble fitting the govenor assembly into the output shaft support. I recall forcing it into place, which I now know NOT to do. Pulled the tailshaft housing (not easy to do on an early A) and govenor assembly, and sure enough, there was my broken ring. I figured that I would have destroyed the output shaft support, but luckily it survived with minimal damage. Slapped it all back together and tore off down the road, anddddd.... IT SHIFTS!!! And good too! Im ready to rebuild another one now, esp since I could just about do it in my sleep at this point. So happy!!!:cheers: