Will GM 200r4 work with factory floor shift location?

I posted the drive shaft length at 52 3/16" but if you've read all my posts you should remember that I replaced my 7 1/4 rear with a HD Chevy 10 bolt posi w/12 bolt axles. Now don't beat me up (again) for using GM stuff on my Barracuda. I would have gladly installed a 8 3/4 if they didn't cost a small fortune where I live. The 10 bolt was free and the parts are very inexpensive. To make the 10 bolt even a better deal...I already had the 15 X 10 1960's slotted rear wheels with Chevy bolt pattern in my garage. So I saved on wheels as well as the rear.
Anyway, most if not all of you here at FABO will have a Mopar differentials so the measurement I gave for the drive shaft will not apply to your build.

treblig