Frame Conectors instructions

well i hope these pic show up!
This first one is with a floor jack holding it in place at rear segment. It point right over the torsion bar mount.
IMG_000010.jpg
The 2nt and 3d show how much i had to bend the rear to make it fit on the from segment.
I held the rear segment of the sub frame in place with several C clamps and then pulled the front part outward, to clear the torsion mount. That's how much i had to bend it to make it line up, up front.

IMG_000008 (2).jpg

IMG_000014 (2).jpg

I can't get a pic to show the bow but this one can kinda show how the sum frame tips to the center of the car.
IMG_000015.jpg
took a pic from the rear of the car forward but don't show the angle either

IMG_000012.jpg