Will GM 200r4 work with factory floor shift location?

I picked up the recommended radiator fittings today along with a 25 foot roll of 5/16" tube and fittings. I got 4 sets of radiator to transmission cooler lines, so I can practice drilling, tapping and soldering. Thanks for the guidance on this Treblig!

Be very careful when you use the Tap drill. You have to keep checking to make sure you go deep enough but not too deep. If you go too deep you'll destroy the flare fitting surface on the other end of the fitting. If you go too shallow the tap will bottom out and you could accidently break it.

treblig