Not Enough Clutch Travel

I installed my 3/4" bore pull type slave cylinder but Im not getting enough clutch disengagement. The throw out bearing is resting against the pressure plate fingers to ensure instant pressure as I press the clutch. I'm well aware I need free play but for now I'm just trying to get this thing working. I set the 3/4" bore master cylinder push rod at the 4 spot welds just below the clutch pedal pivot point. After taking measurements I have a 8:1 pedal ratio. I read that 6:1 is optimal. If I drop the master cylinder push rod to achieve a 6:1 ratio will that give me more clutch travel? This thing is giving me the blues! :banghead: