1970 Swinger 340 Hemi Orange 4 speed
Thanks guys!
Spent a couple hours fibreglassing tonight. I have my third coat on the lead seams.. First coat was pretty much squeezing the fibreglass into every crevice to make sure there were no air pockets. From there it's sanding and applying more as I go until it's close. Tomorrow I will sand all the fibreglass and start stripping the e coat. Hopefully by Wednesday the quarter will have epoxy. Then it's just little details like pumping epoxy into every seam and edge, drip checking where it needs it and touching up the paint I burnt off the inside a piller from welding.
Hopefully I get all this done by Friday so I can start fixing the door gap. I'm going to put the striker and latch on while doing this... I might put the old seal on as well but I can't see that changing anything since i have the rubber bump stops in the door to hold the door where it's going to be.
Thanks guys!
Spent a couple hours fibreglassing tonight. I have my third coat on the lead seams.. First coat was pretty much squeezing the fibreglass into every crevice to make sure there were no air pockets. From there it's sanding and applying more as I go until it's close. Tomorrow I will sand all the fibreglass and start stripping the e coat. Hopefully by Wednesday the quarter will have epoxy. Then it's just little details like pumping epoxy into every seam and edge, drip checking where it needs it and touching up the paint I burnt off the inside a piller from welding.
Hopefully I get all this done by Friday so I can start fixing the door gap. I'm going to put the striker and latch on while doing this... I might put the old seal on as well but I can't see that changing anything since i have the rubber bump stops in the door to hold the door where it's going to be.
