What do you think of my build? 318/390

mini said

Hey guys, halfway done my 318/390 build.
-69 318 block .030 decked .010
-69 894 X Heads 2.02 1.60 3 angle, Bowl Ported and Gasket matched milled .035" 60cc's
-Scat 9000 4.00 Crank
-Scat I beam 4340 arp 2000
-ICON -23cc Pistons 1.465"
-Comp 282S Solid lifter
-RPM Airgap Gasket Matched
-750cfm AED
Roughly 9.7:1

Any Horsepower guesses once I get it together and dynoed?

Click to expand...

I had planned to build almost the exact same engine in a 69 Barracuda.
- 70 318 block .030 decked .010
-596 heads SS Ferrea 2.02 1.60 3 angle, Bowl Ported and Gasket matched 69cc's
-Scat 9000 4.00 Crank (I'll probably go with the cast crank)
-Scat I beam 4340 arp 2000 (I'm using SIR rods)
-ICON -23cc Pistons 1.465" (I'll use these pistons if I can get the Comp Ratio I'm looking for)
- Cam unknown
-RPM Airgap Gasket Matched
-750cfm AED
- adjustable iron rockers
- 340 drivers manifold and 2 1/4" magnum passenger's exhaust manifold with 2 1/2 pipes.
I have all the parts except the crank, cam and pistons. I wanted to run pump gas so 9.2:1 comp ratio (69cc heads).
I've also already installed a modified 2004R transmission w/1800 stall, running 3:08s but have a new set of 4:10s ready to install. I was shooting for 350-375 HP and looking for high torque engine with nothing over 5800 RPM. I shouldn't need any high RPMs with the overdrive!!

You didn't state what head gasket you planned on using??
Treblig