Ignition problems with pick up circuit

In my opinion, starting a new thread was ill advised. It does not allow us to easily follow WT 'ell is it that you are doing

Timing does not cause "chirp." But if you must, CHANGE the timing and see if the chirp goes away

Are you SURE you got the reluctor installed correctly? The CW arrow (for small block) MUST be adjacent to the pin

BUT it might be possible --in this Chieseo world-- for a reluctor to be made incorrectly. Carefully lay your old reluctor over the new, close enough that you can see the relationship of the keyway and the reluctor tips and see if they line up exactly

(You might have an issue with "rotor phasing" Google it)

You replaced the PICKUP COIL? Is that correct?

IT MIGHT also be possible for the electrical connector to be REVERSED on the pickup coil. To repeat, the only way to check this is to check rotor phasing..................:

https://www.google.com/search?num=3...7.7.0....0...1c.1.46.hp..6.7.1098.2jlZQWmmG6w