Mini Sarter Help

This was sent to me by a friend today from a friend of his and should clear everything up.

Starters for Vintage Engines
When the slant six came on the market in 1960, the starter used a direct-drive Bendix setup. This starter was replaced, in the United States, by the new Chrysler-built reduction gear starter. It is with this starter that the ring gear on the torque converter changed.


The reduction gear starter was used on all U.S.-built Chrysler products, except the 1962-1964 Dodge 880 and Chrysler Newports with the manual transmssion. They hung on to the direct drive starter.


In Canada, the slant six engine used the Prestolite direct-drive starter up to 1966, while all V8-powered Chryco vehicles used the reduction-gear starter. So, if you have a Canadian-built 1962-1966 Chrysler product with the slant six, you will need to use the Prestolite starter.


And, if you get your transmission rebuilt, make sure the shop uses the 1961 slant six torque converter. A friend had the Torqueflite transmission on his Canadian-built 1964 Valiant V200 slant six (model VVX1-H-41) rebuilt, and the shop, being an American franchise outfit, used their American parts lists. So, he landed up with an American model 1964 torque converter. When he tried to start the car, it sounded as if the starter and ring gear were not mating. A couple of days later, he cracked the starter gear.


The starter was taken into a local electrical shop and the starter was rebuilt. Again, the starter and ring gear did not seem to mesh. At this point he told me his problems and I checked Chrysler of Canada's parts catalogues for the 1960-1964 Valiants. Sure enough, the starters and torque converters on the Canadian Valiants did not change in 1962, as they did in the U.S. We went to a local yard and acquired the starter, solenoid and associated wiring from a 1972 Dart and installed it in his Valiant. The car fired up the first time the key was turned. I bought his direct-drive starter and used it in my Canadian-built 1962 Valiant, which was in need of a new starter.


Also, the starters from the 273/318 V8's can be used in the slant six, for those vehicles with the reduction gear starter. They will not work in the pre-1962 Chrysler products, or in the 1962-1966 Canadian-built slant six models. Beware, too, that the 1966 Barracuda, Belvedere and Coronet were not built in Canada, so they will have the reduction gear starter.
The reduction gear starter was smaller and lighter than the direct-drive starter. Plus, the solenoid is separate from the starter. As Autolite was the source of the direct drive starter prior to the Ford takeover, it is very similar to the Ford starter. Solenoids for Autolite/Prestolite starters are becoming hard to find, and apparently the more common Ford solenoid will work on the Chrysler starters.