Install and Break In Procedures for New Camshaft Help

Make a mark 2&7/32" clockwise from the TDC slit on the dampener & have the guy running the light/dist to set the dist to that when it fires (with vac adv capped). Read "breakin secrets" at www.mototuneusa.com On mockup check lifters for proper rotation. clean each lifter bore and lifter with brake kleen then lightly lube each lifter and bore with WD40 & set each lifter down on the cam lobe & raise each one up with your middle finger and let go of it & each one should fall down onto it's lobe with a resounding "thunk" & if not it is too tight & will not rotate which is critical for proper cam breakin. The OE drip bolt has a 1/8" hole and you can drill that your self