roller rocker to valve stem off center

[nm9stheham;1970479501]Are these pics with the spring compressed or fully un-compressed? If un-compressed, then look at them each when their respective spring is compressed; the contact point will move as the rocker changes its angle; look at the total range of contact point movement.

Not sure I agree with the comment on the guide wear; one of the points of rollers is to eleimate the side force component on the guides.[/QUOTE]

nm9stheham, the first pics were w valves partially open. Just not sure if thats too close to edge w valve open.
MRL Performance member, mike, has identified issue to be valves too short.
Does anyone have pic of where their roller tip lyes ontop of valve stem with valve closed?
Again, here is pic w my roller w valve closed.