Will GM 200r4 work with factory floor shift location?

Then you disassemble the governor by removing the small wire clip just below the large skinny washer at the bottom of the shaft. Once the wire clip and the washer are removed it basically falls apart. In the last pic you can see the sliding pin that holds the weights in place. The pin fits loose in the holes and is held in place by the inside diameter of the yellow plastic driven gear. When you remove the plastic gear the sliding pin might just fall out on its' own. If the pin falls out the springs inside the weight might "spring" out and you won't know which spring goes where. Take care that you note which spring goes with which weight (it's important). More later..............

treblig