The picture is of the spacer I welded to the clutch pedal that pushes the master cylinder pushrod. I'm using a pull type slave cylinder attached to the tranny crossmember to pull the clutch fork. The master cylinder is Wilwood 260-1304, the slave cylinder is Howe 829. They both have a 1.375 stroke. I'm getting a full 1 inch at the clutch pedal measured at the master cylinder pushrod and 3/4 inch pull at the clutck fork. Does anyone think the pressure plate may not be releasing? I called a local clutch shop and was told they could test the pressure plate. I may do that before I swap master cylinder.