68 GT convertible project
I bought a set of slightly used Magnumforce 2" drop spindles from a member here. I cleaned them up in the parts washer, then gave them a quick bath in EvapoRust to clean a little bit of rust off of them. Today I coated them in RPM and installed the LBJ's. The LBJ's were also coated in RPM.
I also gathered up all of the zinc plated fasteners again. I'm taking them back to the platers tomorrow. I called them and told them they needed to be redone. I think they were mistakingly put in the yellow zinc tank by accident for a short time. They diffinately have a yellow tint to them. We will see what they say tomorrow.
I bought a set of slightly used Magnumforce 2" drop spindles from a member here. I cleaned them up in the parts washer, then gave them a quick bath in EvapoRust to clean a little bit of rust off of them. Today I coated them in RPM and installed the LBJ's. The LBJ's were also coated in RPM.
I also gathered up all of the zinc plated fasteners again. I'm taking them back to the platers tomorrow. I called them and told them they needed to be redone. I think they were mistakingly put in the yellow zinc tank by accident for a short time. They diffinately have a yellow tint to them. We will see what they say tomorrow.