Fuel cell / Exhaust issue

I have a Dart but...

I didn't do it for the same reason as you need to do it, but I ran my 2.5 pipe under the connector and the angled it up towards the body edge so it would basically go under ,up and out if you can picture that.
Then I cut the tips at the same angles as the body forward to back and up and down so it created an interesing bologna cut tip.
I'll see if I can find a decent pic of it and post it.

Found one but I had to lighten the pic quite a bit so you could see the pipe clearly.
They are not as noticable in normal light (second pic)