**73 Scamp Mini Pro-Street Engine Swap**

Finally pulled the drive shaft and replaced the Trans tail shaft seal with the boot version. For some reason my non boot seal seeped a little. While I was down there I drained the Trans fluid and prepped the TBVB for install. I'm letting the pan drain over night so I hopefully don't get so dirty on the swap. Gotta pull the seat back out and drill the floor for the shift cable too.

I also drilled and tapped the FP block off plate for the fitting that well go to vac gauge.

Going to try and get the TBVB and shifter all hooked up by Tuesday. We shall see.