One wire lock-up, 4 spd automatic w overdrive into A-body.

I test fit the Reid Bellhousing to my old tired 5.9 Magnum. In part to see where to mark the bellhousing to cut the hole for the crank position sensor, and to see if it fit without hitting anything. I may have to loose my 90 degree oil filter adapter.It did fit nicely otherwise.

I also measured from where it bolts on to the face of the back of the block to the end of the tailshaft. Treblig, a few others and I speculated about this earlier in this thread, but here is a rough measurement. Here's the pics. It looks like it comes in at 28 1/4 inches, but I'll take a more accurate measurement when I get off work, and see if the torque converter has the correct dimentions.