Lets say your ballast resistor is laying down where there are to terminals at each end.
Basically you just want to consider it like there is a wire for the two top terminals, and a wire for the two bottom terminals.
Connect the two wires that go to the two top terminals together, and the two bottom terminals together.
This is crude, but just figure you want to bypass the red coils in this pic.
No, just the module that triggers the spark of the coil.
But even the original style coil can run with a Pertronics unit without a ballast resistor due to the low dwell time.
HEI coils can be used with the Pertronics unit also.
