Project Confused

Looks Good man!

A few questions:

1. The track width was the reason for narrowing the cross member correct?

2. Because I have not done any real research into this yet.... Could you have gotten away with leaving the track width alone and running a wheel something like the factory vette offset? Would it have fit under the fenders?

3. Having to make clearance for the oil pan, where are you going to add material back in? At the front near the rack or do you have something else planned toward the rear of the motor to replace all the structure you'll have to remove?

4. Are you going to have to notch the factory frame rails to allow clearance for travel of the upper control arms?


You are doing great work man. Love to see this stuff!